P0020
A Camshaft Position Actuator Circuit (Bank 2)
If your vehicle's onboard computer has flagged the diagnostic trouble code P0020, it refers to a detected anomaly regarding "A Camshaft Position Actuator Circuit (Bank 2)". This systemic engine fault needs a targeted check before symptoms expand.
Driver's Summary
Code P0020 means your vehicle detected a problem with the a camshaft position actuator circuit (bank 2) system. Drivers typically experience engine hesitation, poor drivability, check engine light on when this code is active. The vehicle is usually drivable, but the root cause needs attention soon to avoid more expensive repairs down the road.
Symptoms
Engine hesitation, poor drivability, check engine light on
Common Causes
- Failed Bank 2 intake VVT solenoid
- Open or shorted wiring to the VVT solenoid
- Corrosion in the electrical connector
- Failed PCM
How to Fix
- 1 Test and replace Bank 2 intake VVT solenoid
- 2 Trace and repair damaged wiring harness
- 3 Clean electrical connector contacts
- 4 Test PCM output voltage
Technical Explanation
Detection of P0020 occurs when the ECM cross-references multiple sensor inputs and determines that the reported values are physically inconsistent or out-of-range. Sensor output is cross-validated against complementary sensor data (such as MAF vs. MAP correlation, or upstream vs. downstream O2 comparison) to confirm the fault is genuine and not a result of a sensor reading an actual engine condition. The fault remains stored in memory even after the MIL is cleared; it becomes a confirmed DTC after failing two consecutive drive cycles, and the PCM logs a freeze frame record of the engine's exact operating state at the moment of detection.
Is It Safe to Drive?
Medium-severity fault: the car functions but not optimally. The failed bank 2 intake vvt solenoid issue will not resolve itself and will cause measurable long-term wear. A repair in the $100–$400 range now avoids far higher costs later.
Mechanic's Pro Tip
For P0020, test the solenoid's coil resistance with a multimeter before ordering parts — most solenoids should read between 14 and 40 ohms; an open (infinite resistance) or short (near zero) confirms it's failed electrically. Also verify the PCM is commanding the solenoid by backprobing the connector with a test light during the relevant operating condition — if there's no command signal, the fault is in the PCM or wiring, not the solenoid itself.
Related Fault Codes
Frequently Asked Questions
What does OBD2 code P0020 mean?
OBD2 code P0020 refers to A Camshaft Position Actuator Circuit (Bank 2). If your vehicle's onboard computer has flagged the diagnostic trouble code P0020, it refers to a detected anomaly regarding "A Camshaft Position Actuator Circuit (Bank 2)". This systemic engine fault needs a targeted check before symptoms expand.
What are the most common symptoms of DTC P0020?
Drivers experiencing code P0020 typically report: Engine hesitation, poor drivability, check engine light on.
Is it safe to drive with trouble code P0020 active?
Medium-severity fault: the car functions but not optimally. The failed bank 2 intake vvt solenoid issue will not resolve itself and will cause measurable long-term wear. A repair in the $100–$400 range now avoids far higher costs later.
How much does it cost to fix code P0020?
The estimated repair cost for P0020 ranges from $100 to $400 USD. VVT Solenoid replacement: $150 - $400
VVT Solenoid replacement: $150 - $400
Need Professional Diagnostic Assistance?
Always verify sensor signals and wiring integrity with an OBD2 scanner before purchasing replacement parts.
Explore All Powertrain Codes →