P0118
Engine Coolant Temperature Sensor 1 Circuit High
If your vehicle's onboard computer has flagged the diagnostic trouble code P0118, it refers to a detected anomaly regarding "Engine Coolant Temperature Sensor 1 Circuit High". This systemic engine fault needs a targeted check before symptoms expand.
Driver's Summary
When your OBD2 scanner shows P0118, the engine control module has flagged an issue specifically related to engine coolant temperature sensor 1 circuit high. In practice, this fault causes cooling fans running always, hard start when cold, rich air-fuel mixture. This is a moderate-severity fault — plan a repair shop visit within the week to keep it from escalating.
Symptoms
Cooling fans running always, hard start when cold, rich air-fuel mixture
Common Causes
- Bad ECT sensor
- Corroded connector
- Low engine coolant
- Short in wiring
How to Fix
- 1 Replace ECT sensor
- 2 Repair sensor connector
- 3 Check coolant level
- 4 Verify wiring continuity
Technical Explanation
The ECM detects code P0118 by continuously monitoring the relevant sensor circuit against calibrated threshold values stored in its non-volatile memory. The module measures the voltage return on the 5V reference circuit, comparing it to the expected signal envelope at current engine load and RPM. A deviation greater than the calibrated threshold — typically ±10% outside the normal operating window — flags the fault. The MIL illuminates after the fault is confirmed on two consecutive drive cycles, and the freeze frame data captured at first detection is stored in the PCM's memory for diagnostic reference.
Is It Safe to Drive?
While the vehicle is typically drivable with P0118 active, avoid towing, aggressive acceleration, or extended highway driving until the fault is resolved. The primary risk is accelerated wear on bad ect sensor and corroded connector.
Mechanic's Pro Tip
Before replacing any component on P0118, spend 5 minutes inspecting the wiring harness and connector first — corrosion, chafed insulation, and backed-out pins cause the majority of these faults and cost nothing to fix. Use a multimeter to measure voltage drop across the connector pins under load; anything above 0.1V indicates excessive resistance that will cause intermittent failures even after replacing the sensor.
ECT sensor: $40 - $100; Labor: $100