P0318
Rough Road Sensor A Signal Circuit
When a vehicle powertrain module registers the fault code P0318, it points directly to an internal system malfunction identified as "Rough Road Sensor A Signal Circuit". Operating your engine under this condition may degrade long-term fuel maps.
Driver's Summary
Storing code P0318 is your car's way of telling you something is wrong with the rough road sensor a signal circuit. In practice, this fault causes false misfire codes, traction control issues, check engine light. This code won't leave you stranded, but it indicates a real issue that will only get easier and cheaper to fix sooner rather than later.
Symptoms
False misfire codes, traction control issues, check engine light
Common Causes
- Faulty rough road sensor
- Corroded electrical connector
- Short to ground in sensor wiring
- Damaged reluctor ring on wheel hub
How to Fix
- 1 Replace rough road sensor
- 2 Clean connector contacts
- 3 Repair shorted wiring
- 4 Inspect wheel speed sensors
Technical Explanation
The ECM detects code P0318 by continuously monitoring the relevant sensor circuit against calibrated threshold values stored in its non-volatile memory. The PCM monitors crankshaft rotational velocity via the CKP sensor at a resolution of individual tooth gaps on the reluctor ring. A combustion event in each cylinder produces a measurable acceleration spike; its absence or weakness is flagged as a misfire event within a 200-revolution or 1000-revolution test window. The MIL illuminates after the fault is confirmed on two consecutive drive cycles, and the freeze frame data captured at first detection is stored in the PCM's memory for diagnostic reference.
Is It Safe to Drive?
Code P0318 has minimal impact on immediate driving safety. However, the underlying faulty rough road sensor issue will cause this vehicle to fail an emissions inspection and may gradually affect fuel economy if left unrepaired.
Mechanic's Pro Tip
Before replacing any component on P0318, spend 5 minutes inspecting the wiring harness and connector first — corrosion, chafed insulation, and backed-out pins cause the majority of these faults and cost nothing to fix. Use a multimeter to measure voltage drop across the connector pins under load; anything above 0.1V indicates excessive resistance that will cause intermittent failures even after replacing the sensor.
Related Fault Codes
Frequently Asked Questions
What does OBD2 code P0318 mean?
OBD2 code P0318 refers to Rough Road Sensor A Signal Circuit. When a vehicle powertrain module registers the fault code P0318, it points directly to an internal system malfunction identified as "Rough Road Sensor A Signal Circuit". Operating your engine under this condition may degrade long-term fuel maps.
What are the most common symptoms of DTC P0318?
Drivers experiencing code P0318 typically report: False misfire codes, traction control issues, check engine light.
Is it safe to drive with trouble code P0318 active?
Code P0318 has minimal impact on immediate driving safety. However, the underlying faulty rough road sensor issue will cause this vehicle to fail an emissions inspection and may gradually affect fuel economy if left unrepaired.
How much does it cost to fix code P0318?
The estimated repair cost for P0318 ranges from $80 to $250 USD. Sensor replacement: 100 - 250
Sensor replacement: 100 - 250
Need Professional Diagnostic Assistance?
Always verify sensor signals and wiring integrity with an OBD2 scanner before purchasing replacement parts.
Explore All Powertrain Codes →